Paradyne ACCULINK 3172 Manuale Utente

ACCULINK® 3172 and 3174E1 DSU/CSUQuick ReferenceDocument No. 3170-A2-GL10-10

8Table 4. DTE Channel Configuration OptionsOption Factory Comments/DescriptionDTE Channels: TS16 Selects TS16 for signaling or assigns DS0 channels on

9Table 5. Data Port Channel Configuration Options (1 of 2)Option Factory Comments/DescriptionAssign To: NETAssigns this port to channels on the Networ

10Start At: Clear Clears (unassigns) channels for this port.N1 (D1)N2 (D2)N3 (D3)•••N31 (D31)This configuration option appears if the “Assigned By” co

11Table 6. General Configuration OptionsOption Factory Comments/DescriptionPri Clk Src:NETSelects the primary clock source for the DSU/CSU.DTEPrtnIntE

12Com Rate:(Communication Port Rate)1.2 Selects the bit rate for the COM port.2.44.89.614.419.238.4Char Length: 7 Selects the character length for the

13Table 8. Alarm Configuration OptionsOption Factory 1 Comments/DescriptionAlrm Msg: Enab Determines whether alarm messages are routed to the ASCII te

14Com IP Adr: Edit The IP address for the COM port when the COM port is configured for SNMP. ClearCom NetMask: Edit The Subnet Mask needed to access t

15Table 10. SNMP Trap Configuration OptionsOption Factory 1 Comments/DescriptionNum Trap Mgrs:12–6The number of trap managers supported by the device

16Important Safety Instructions1.Read and follow all warning notices and instructions marked on the product or included in the manual.2.This product i

1710.In addition, if the equipment is to be used with telecommunications circuits, take the following precautions:— Never install telephone wiring dur

Copyright © 2001 Paradyne Corporation.All rights reserved.Printed in U.S.A.Warranty, Sales, Service, and Training InformationContact your local sales

18CE MarkingModels 3172-A1-410 and 3174-A1-410 of this product are marked with the CE mark. This mark has been affixed to demonstrate full compliance

1ACCULINK® 3172 and 3174 E1 DSU/CSUQuick ReferenceDocument Number 3170-A2-GL10-10July 2001Product Documentation OnlineComplete documentation for this

2Quick Start ProcedureThe following procedure is for experienced DSU/CSU users who are familiar with the 317x DSU/CSU installation process and have no

3Cabling ExamplesThe DSU/CSU is supplied with an AC power module. You must provide the DTE and network cables.Optional cables that you can order from

4Configuration OptionsConfiguration options are accessed from the Cnfig branch of the front panel menu.DSU E1 CEPTStatTe s t98-14606aDevHsSTestPerfTSt

5Factory default configuration options are shown in boldface type in the following tables.Table 1. DTE Interface Configuration OptionsOption Factory C

6Port LB:DisabPort-initiated Loopbacks, allows Loopbacks to be initiated through the port by the external DTE.DTLBDCLBBothAll Ones: Disab All ones sen

7Near-end:DisabSpecifies whether the device will maintain near-end performance statistics.MaintSendBothFar-end:DisabSpecifies whether the device will